Fig Pro Audio

How to get started with FigSTRIP

FigSTRIP puts a whole recording chain on one track: a preamp, filters, a compressor and gate, two EQs and a tape stage. That's a lot of controls in one window, so this guide gives you an order to work in. Start from a preset, set the filters, control the dynamics, shape the tone, then add colour and set the level.

Install it and pick Channel or Bus

Download the free 14-day trial, which has every feature working, run the installer and restart your DAW. One licence covers Mac and Windows.

FigSTRIP has two modes, switched with one control:

Switching to Bus links the stereo channels and sets the rest of the strip up for a bus, but only on sections you haven't touched. It's one undo step, and it crossfades, so you can switch while the song plays.

Start from a preset

There are 32 factory presets for vocals, drums, bass, guitar, keys and buses. Pick the one closest to your track, then adjust. You can save your own presets into folders, and A/B plus undo and redo mean you can always try an idea and get back to where you were.

Understand the six sections

Every section has its own IN switch, and you can drag them into any order. If you only want to change one thing, flip Dynamics before or after the EQ with a single switch.

Work in this order

  1. Clean up with the Filters. Raise the high-pass until the track stops sounding muddy with the rest of the song playing, but before it sounds thin. Bring the low-pass down only if the top is harsh or noisy.
  2. Control the level with Dynamics. Set the compressor so the gain-reduction needle moves on the loud parts and rests on the quiet ones. The transfer curve shows where your signal sits against the threshold. Use the gate or expander only if there's bleed or noise between phrases.
  3. Shape broadly with Color EQ. Its wide bands are made for quick, musical moves: a little more body, a little more top.
  4. Fix precisely with G EQ. Use a narrow band for one resonance or a clash with another instrument. Small cuts usually beat big boosts.
  5. Add colour with Preamp and Tape. Drive in the Preamp thickens, Tape glues and rounds off transients. Switch each one in and out to check it's actually helping.

This is a starting order, not a rule. If you want the compressor to react to the EQ'd sound, or the tape to sit before the EQ, drag the sections around.

Set the output and check the level

The Output section has a fader, pan, polarity, and Mix for parallel processing. Turn on Auto Gain while you work: it keeps the processed sound at the level you started with, so you hear the tone, not the loudness. Watch the peak meters, and the correlation meter on stereo tracks.

Using Bus mode

On a drum bus, a group or the mix bus, switch to Bus. The glue compressor has threshold, stepped attack and release with a two-stage Auto release, 2, 4 and 10 to 1 ratios, make-up, a sidechain high-pass and Mix for parallel compression. For gentle glue, a low ratio and only a little gain reduction on the loudest parts is a sensible start. The big meter switches to gain reduction in this mode so you can see it.

Tracking and CPU

FigSTRIP runs 2x or 4x oversampling for the cleanest Preamp and Tape, or a Zero Latency mode for when you're recording through it. It handles mono, stereo and mono-to-stereo, with Linked, Dual Mono and Left/Right Independent stereo modes, and an external sidechain.

Where to go next

The same Fig Pro Audio account that runs FigAMP and FigGutEQ activates FigSTRIP. When you're ready to keep it, click Buy / Activate in the plugin, or buy FigSTRIP here.