Fig Pro Audio

Guides

How-to guides for recording guitar and bass at home, and a getting-started guide for each Fig Pro Audio plugin, written by Al Figlioli, the developer of FigAMP.

Plugin guides

FigAMP · Amp plugin

Get Started with FigAMP

A first session step by step: set the INPUT level, pick an amp and press Classic Tone, shape the sound, set the output and save your own presets.

FigGutEQ · Guitar EQ

Get Started with FigGutEQ

Before or after the amp, Tuning Lock, PRE AMP and POST AMP presets, the eight guitar bands and Pick Attack.

FigSTRIP · Channel strip

Get Started with FigSTRIP

Channel or Bus mode, the six sections and an order to work in, plus Auto Gain, Mix and Zero Latency for tracking.

FigTECH EQ · Tube program EQ

Get Started with FigTECH EQ

Link, Dual or Mid-Side, the low boost and atten trick, the high boost and atten, and Drive on the analog panel.

FigVERB · Free reverb

Get Started with FigVERB

Activate it free, choose a mode, and use Pre-Delay, Low Cut and Duck to keep the guitar in front of the reverb.

Recording guides

Everything in these works with any amp plugin. If you're new to recording direct, start with the clean DI guide: the other two build on it.

Start here · Guitar

Record a Clean DI Guitar Signal: No Noise, No Clipping

How to get a quiet, unclipped DI guitar signal into your DAW: interface gain, cables, hum and gating, explained by a plugin developer who plays.

Guitar · Mixing

Dial an Amp Sim for the Mix, Not for Solo

Why the guitar tone that sounds huge on its own gets lost in a song, and how to set gain, EQ, cab and width on an amp sim so it sits in the mix.

Bass

Record Bass DI Plus Amp Tone at Home

Record a clean bass DI and an amp or amp-sim track together, line them up in time and polarity, and blend them so the low end stays solid.