Fig Pro Audio

How to get started with FigTECH EQ

FigTECH EQ is a stereo program equalizer inspired by classic 1960s passive tube program EQs. It doesn't have many controls, and that's the point: a few broad, musical moves, then tubes and transformers to round them off. This guide covers where to put it, how to set up the pair of units, the low-end trick these equalizers are famous for, and the analog panel.

Install it and put it in the right place

Download the free 14-day trial, which has every feature working, run the installer, and restart your DAW. On Mac it comes as an Audio Unit, VST3, CLAP and standalone app; on Windows as VST3, CLAP and standalone.

FigTECH EQ is a tone shaper, not a surgical fixer. Put it where you want broad colour:

Choose Link, Dual or Mid-Side

Two complete units share one window, and every control exists twice. The keys on the brand plate decide how the pair is used:

COPY L>R and COPY R>L copy one unit's settings to the other. On a mono track FigTECH EQ runs as one unit.

Start from a preset

There are 15 factory presets for drums, bass, vocals, guitars, the mix bus and mastering, from Kick Weight to M/S Master Air. Pick the one closest to your source, then adjust. Save your own presets in folders, and use A/B to compare two settings, each keeping its own edits.

Use the low-end trick

Pick a frequency with CPS: 20, 30, 60 or 100 Hz. LOW BOOST lifts a broad shelf by up to +14 dB and LOW ATTEN cuts by up to 19 dB.

On most equalizers, boosting and cutting the same frequency cancel out. Here they don't, because the LOW ATTEN shelf turns over higher than the LOW BOOST shelf. Turn both up at the same CPS and the deep lows get bigger while the boxy low mids clear out. At 60 Hz with both at 5, that's about +7.6 dB of lows and -4.3 dB around 1 kHz.

Try it on a kick drum or bass: set CPS to 60 Hz, bring LOW BOOST up until the bottom feels right, then add LOW ATTEN until the box goes away.

Add air with the high boost, tame fizz with the high atten

Hover over any dial to see its setting and what it does in dB.

Set the level and compare fairly

Boosts make things louder, and louder always sounds better. Use OUTPUT (off to +12 dB) and the VU meters, where 0 VU is -18 dBFS, to match the level, then flip EQ IN/OUT to hear the difference. EQ OUT takes the equalizer out but leaves the tubes and transformers in circuit, as on the hardware. POWER off is a true bypass. With every boost and cut at 0, the level through the unit doesn't change.

Open the analog panel

Click ANALOG PANEL for the response curve and the controls the original panel never had:

Where to go next

The same Fig Pro Audio account activates FigTECH EQ, FigAMP, FigGutEQ and FigSTRIP. When you're ready to keep it, click TRIAL in the top bar or use the gear menu, or buy FigTECH EQ here. See the FigTECH EQ page for the full feature list.